...
Figure 12 Cabling a Single Appliance and an HA Pair to a Network
...
...
...
...
...
...
...
...
...
...
...
...
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed Image Removed Image Removed 
Image Removed Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed 
Image Removed When cabling a single Infoblox appliance to the network, connect an Ethernet cable from the LAN1 port on the appliance to a switch or router. When cabling a pair of Infoblox appliances to the network for high availability, connect Ethernet cables from the LAN1 and HA ports on each appliance to a switch or router. Appliance–Network Connectivity
...
- (AppliestoInfobloxPT-1405, TrinzicTE-1415andTE-1425appliances.) To ensure that VRRP (Virtual Router Redundancy Protocol) works properly, configure the following settings at the port level for all the connecting switch ports (HA, LAN1, and LAN2):
- Spanning Tree Protocol: Disable. For vendor specific information, search for "HA" in the Infoblox Knowledge Base system at https://support.infoblox.com/
- Trunking: Disable
- EtherChannel: Disable
- IGMP Snooping: Disable
- Port Channeling: Disable
- Speed and Duplex settings: Match these settings on both the Infoblox appliance and switch
- Disable other dynamic and proprietary protocols that might interrupt the forwarding of packets
Use the Grid Manager from a management system to access, set up and administer the Infoblox appliance. For management system requirements and access instructions, see Accessing the Infoblox 1405 Series Appliance
...
.
...
