...
| Anchor | ||||
|---|---|---|---|---|
|
3. With one person on each side, lift the appliance and position it in the equipment rack.
...
| Anchor | ||||
|---|---|---|---|---|
|
4. Align the mounting holes on the chassis slide rails with the rear-most mounting holes on each side of the chassis. Ensure that you place the chassis slide rails in the correct orientation. Otherwise, the mounting holes do not align properly.
...
| Anchor | ||||
|---|---|---|---|---|
|
6. Select a desired location and secure the rack slide brackets to the rear posts of the equipment rack with two (2) 10-32 screws on each side of the rack, as shown in Figure 9.
...
| Anchor | ||||
|---|---|---|---|---|
|
...
3. Extend the rack rail assembly backwards, align the mounting holes on the chassis slide rails with the required cage nuts, and fasten the back end of the rack rail to the two cage nuts on the rear post of the designated space. As noted, the rack rail assembly has an extension range from the minimum of 600mm to a maximum of 900mm.
...