Versions Compared

Version Old Version 1 New Version 2
Changes made by

Aliaksei Shautsou

Olga Nekrutkina

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Connect an Ethernet cable from the LAN1 port on the PT-4000 to the network switch or router, as indicated in Figure 10.
  2. Use the Infoblox GUI to access the Infoblox appliance from a management system. Through the Infoblox GUI, you can set up and administer the appliance. For management system requirements and access instructions, see Accessing the Appliance .


Anchor
bookmark18
bookmark18
Figure 9 Cabling a Single Appliance to the Network


Management System
Switch or Router
Infoblox Appliance
Image Removed
Image Removed
Image Removed
Image Removed
Image Removed
Image Removed
Image Removed
Image Removed
Image Removed
Image Removed
Image Removed
Image Removed
Image Removed
When cabling a single Infoblox appliance to
the network, connect an Ethernet cable from the LAN1 port on the appliance to a switch or router.  

Drawio
bordertrue
viewerToolbartrue
fitWindowfalse
diagramName9
simpleViewerfalse
width
diagramWidth1121
revision1


...

Note: Infoblox appliances automatically negotiate the optimal connection speed and transmission type (full or half duplex) on the physical links between its LAN1, LAN2 and MGMT ports and the Ethernet ports on a connecting switch. If the two appliances fail to auto-negotiate the optimal settings, see the Infoblox NIOS Administrator Guide for steps to resolve the problem.

...