The Network Automation NT-1400 ships with one (1) AC power supply module. You can order an additional AC power supply to set up a hot-swappable redundant 1+1 configuration. In the 1+1 configuration, Infoblox recommends using the power cables shipped with the appliance to connect each power supply to separate power circuits. In the event of a power failure on one circuit, the appliance can then operate on the other circuit.
...
Note: If your appliance comes with one power supply and an empty module, ensure that the power supply is in the PSU #1 slot and the empty module in the #2 slot. You cannot switch them.
Network Automation appliances with a single power supply will go dark if the single power supply stops working for any reason. Infoblox recommends ordering an additional Power Supply for a redundant 1+1 configuration.
...
To power the appliance:
- Connect a power cable between the power connector on the back of the appliance and a properly grounded and rated power circuit that meets the provisions of the current edition of the National Electrical Code, or other wiring rules that apply to your location. Make sure that the outlet is near the appliance and is easily accessible.
...