...
- Log in to the Standby Operations Center command line via SSH using the admin/admin system credentials.
- Execute the following administrative shell CLI commands on a newly installed or reset Standby Operations Center instance:
- Define the management port IP configuration for the Standby Operations Center:
admin-na206.corp100.com> local> configure server - Install the license for the Standby Operations Center:
- For a physical appliance, generate a license by running the license generate command. For more information, see license generate command.
- For a virtual appliance, run admin-na206.corp100.com> local> license <license filename>.gpg.
- For a physical appliance, generate a license by running the license generate command. For more information, see license generate command.
- Define server settings for the Standby Operations Center:
admin-na206.corp100.com> local> configure server
- Define the management port IP configuration for the Standby Operations Center:
Make a note of your settings for Step 6 of this Procedure.
...
3. Verify your settings by entering the following commands:
admin-na206.corp100.com> local> show settings
List the complete config settings for the Standby Operations Center.admin-na206.corp100.com> local> show license
Show the installed license for the Standby Operations Center.
...
5. Using the administrative shell on the Standby Operations Center, restore the database archive on the Standby Operations Center. Restore time depends upon the size of the database, and may take several hours for a large system.
admin-na206.corp100.com> local> restore ExampleNet_4050201203200004-20130221-641
...
7. In the administrative shell on the Standby Operations Center, configure the VPN tunnel server on the Standby Operations Center using the same VPN subnet and other settings as on the Primary. When asked for the Server Public Name or IP address, be sure to enter the correct value for the Standby Operations Center. Do not configure a reference collector. The following listing is a sample capture for an entire session:
admin-na206.corp100.com>local> configure tunserver+++ Configuring CA Settings
...
admin-collector111.corp100.com> local> reset tunclient admin-collector111.corp100.com> local> register
13. Verify Operations Center collector registration and communication by entering the following:
...