Versions Compared

Old Version 2

changes.mady.by.user Viktoryia Varapayeva

Saved on

compared with

New Version 3

changes.mady.by.user Viktoryia Varapayeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Log in to the Standby Operations Center command line via SSH using the admin/admin system credentials.
  2. Execute the following administrative shell CLI commands on a newly installed or reset Standby Operations Center instance:
    1. Define the management port IP configuration for the Standby Operations Center:
      admin-na206.corp100.local> configure local> configure server
    2. Install the license for the Standby Operations Center:
      • For a physical appliance, generate a license by running the license generate command. For more information, see license generate command.
      • For a virtual appliance, run adminrun admin-na206.corp100.local> license local> license <license filename>.gpg.
    3. Define server settings for the Standby Operations Center:
      admin-na206.corp100.local> configure local> configure server

Make a note of your settings for Step 6 of this Procedure.

...

7. In the administrative shell on the Standby Operations Center, configure the VPN tunnel server on the Standby Operations Center using the same VPN subnet and other settings as on the Primary. When asked for the Server Public Nameserver public name or IP address, be sure to enter the correct value for the Standby Operations Center. Do not configure a reference collector. The following listing is a sample capture for an entire session:

...

14. In NetMRI UI, log back in to the Standby Operations Center.

15. In Settings > Setup > Tunnels and Collectors, verify that each of the registered collectors is online. The Operations Center will begin receiving data from collectors immediately after the connection is established. Data processing and analysis will catch up in a time interval similar to how long the collectors were offline.

1516. In Settings > Database Settings > Scheduled Archive, define the new archiving settings that you will need for the new Operations Center system, including enabling automatic archiving, defining the recurrence pattern, and defining the remote systems that will receive the periodic archives.