...
- Log in to the Standby Operations Center command line via SSH using the admin/admin system credentials.
- Execute In the administrative shell, execute the following administrative shell CLI commands on a newly installed or reset Standby Operations Center instance:
- Define the management port IP configuration for the Standby Operations Center:
admin-na206.corp100.local> configure local> configure server
- Install the license for the Standby Operations Center:
- For a physical appliance, generate a license by running the
license generate
command. For more information, see license generate command. - For a virtual appliance, run
admin-na206.corp100.local> license local> license <license filename>.gpg
- For a physical appliance, generate a license by running the
- Define server settings for the Standby Operations Center:
admin-na206.corp100.local> configure local> configure server
- Define the management port IP configuration for the Standby Operations Center:
Make a note of your settings for Step 6 of this Procedure.
...
3. Verify your settings by entering the following commands:admin-na206.corp100.local> show settings
a. List the complete config settings for the Standby Operations Center
...
:
admin-na206.corp100.local> show
...
settings
b. Show the installed license for the Standby Operations Center:
admin-na206.corp100.local> show license
4. Via SCP, manually transfer the Primary Operations Center database archive to the Standby Operations Center.
...