Page Comparison

You can enable and disable FIPS mode from the Infoblox serial console CLI only. Do the following to set FIPS mode on the appliance:

1. Connect Log in to the serial console using the following command:
   /import/lab/bin/console_connect -H host_nameInfoblox CLI using a superuser account.
2. Enable FIPS mode using the following command:
   Infoblox > set fips_mode
3. Reboot the appliance, connect to the serial console and use the following command to check if the FIPS mode is enabled:
   Infoblox > show fips_mode
4. Verify if the following files exist in the directories mentioned:

...