Content Comparison

...

NetMRI classifies Meraki cameras and phones as end hosts and other Meraki devices as network devices.

To add and configure Cisco Meraki discovery, complete the following:

1. Make sure that you enable SDN and SD-WAN polling in Settings icon –> Setup –> SDN/SD-WAN Polling. For more information, see Configuring SDN and SD-WAN Polling Settings.
2. Choose Settings icon –> Setup –> Discovery Settings –> SDN.
3. Click New.
4. In SDN Type, select Cisco Meraki.
5. Complete the following:
   
   • Config Name: Specify a short and unique name for the current Cisco Meraki configuration.
   • Network Interface: Select the interface that will be used to access the device. In parentheses next to the interface name is displayed the name of the associated collector. As Cisco Meraki infrastructure may have overlapping IP addresses in different network views, you should explicitly specify a network interface exposed to the internet.
   • Protocol: HTTPS by default.
   • Address: Enter the hostname or IP address of the Cisco Meraki Dashboard API. By default it is api.meraki.com.

   • API Key: Access key required to use Cisco APIs.

     Note
     title Note
     NetMRI uses Meraki API version 0.4.

     
     

   • Use Global Proxy Settings: Select if you want to use a Proxy server for connectivity with the Cisco Meraki device. For more information, see Configuring Proxy Settings for SDN Discovery.
6. Click Test Connection to check if the device is reachable and the provided credentials are correct. The connection test results are also written to the syslog.
7. Click Add or Add & Discover.

...