Page Comparison

...

For more information, see Configuring Virtual Scan Interfaces. 

To configure a physical scan interface, complete the following:

1. Go to Click the Settings icon > Setup > Scan Interfaces.
2. Hover over the Action icon for any of the physical ports and select Edit from the menu.
3. In Network View, choose one of the following:
   • Select Existing: Choose a network view from the list of existing ones that are defined on the system:
     • Select the view from the drop-down list.
     • Selecting Unassigned as the Network View leaves the interface in a disabled state.
   • Create New: Create a new network view:
     • Enter the name for the new network view.
     • Enter a comment describing the view. These values can be edited at a later time.
4. Enter IPv4 or IPv6 information, or both:
   • IPv4 Address: The IPv4 address for the scan interface.
   • IPv4 Subnet Mask:  The IPv4 subnet mask for the scan interface.
   • IPv4 Default Gateway: The IPv4 default gateway for the scan interface.
   • IPv6 Address: The IPv6 address for the scan interface.
   • IPv6 Subnet Mask: The IPv6 subnet mask for the scan interface.
   • IPv6 Default Gateway: The IPv6 default gateway for the scan interface.
5. In Primary DNS Server, specify the primary DNS server for the scan interface.
6. In Secondary DNS Server, specify the primary DNS server for the scan interface.
7. In Search Domains, specify valid hostnames separated by commas.
8. Click Save.

...