...
To configure a static IP for NetMRI, do the following:
1. In the administrative shellAdministrative Shell, enter configure ip and then complete the following:
a. Enter the Management IP Address: the IPv4 address of the management interface of NetMRI.
b. Enter the Management Subnet Mask: the subnet mask of the management interface of NetMRI.
c. Enter the Management Gateway Address: the IPv4 default gateway of the management interface of NetMRI.
d. Enter the Primary DNS Server: the primary DNS server for the NetMRI appliance.
e. Enter the Primary DNS Domain: the DNS domain name for NetMRI.
2. In the Current Settings section, review your entries.
a. When prompted to edit the settings, enter n and press Enter.
b. When prompted to configure the IP settings, enter y. Wait while NetMRI configures the network and sets the web interface to use the new IP address.
c. When prompted, enter y to complete the configuration.
3. At the command prompt, enter configure server and then complete the following (values you entered in the configure ip command are the default values here):
a. Enter your network, server, and domain names.
b. Enter the NTP time server if applicable.
c. Enter the time zone region to be used for timestamps within NetMRI.
d. Enter the location within your time zone region.
e. Enter IP address and the Subnet Mask for the NetMRI system. Enter the IPv6 address and the IPv6 prefix if applicable.
f. Enter the default gateway. Enter the IPv6 default gateway if applicable.
g. Enter n for the scan port.
h. Enter the DNS server(s) for NetMRI.
i. Review your settings. If you accept the settings, enter n.
j. Enter y to configure the server with the settings you just entered.
k. Wait while NetMRI configures the network and sets the web interface to use the new IP address.
l. When prompted, enter y.
m. Restart the server and reboot.
n. At the command prompt, enter exit to log out.
Continue to the following section, Running the Setup Wizard.
...