Versions Compared

Version Old Version 5 New Version 6
Changes made by

Viktoryia Varapayeva

Viktoryia Varapayeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. At the CLI (command-line interface) command prompt, enter configure ip, and then complete the following:
    • Enter the Management IP Address: The IPv4 address of the management interface of the NetMRI, for example, 192.168.10.10.
    • Enter the Management Subnet Mask: The subnet mask of the management interface of the NetMRI, for example, 255.255.255.0.
    • Enter the Management Gateway Address: The IPv4 default gateway of the management interface of the NetMRI, for example, 192.168.10.1.
    • Enter the Primary DNS Server: The primary DNS server for the NetMRI to query, for example, 172.23.16.20.
    • Enter the Primary DNS Domain: The DNS domain name for the NetMRI, for example, infoblox.local.
  2. In the Current Settings section, review your entries.
  3. At the Edit these settings? <y/n> [n] prompt, enter n and then press Enter.
  4. At the Configure these IP settings? <y/n> [y] prompt, enter y to configure the IP settings. Wait while NetMRI configures the network and sets the web interface to use the new IP address.
  5. When prompted, enter y to complete the configuration.
  6. At the command prompt, enter configure server, and then complete the following (values you entered in the configure ip command will be the default values here):
    • Enter y to continue.
    • Enter your network name, for example, MyNetwork.
    • Enter your server name, for example, MyNetMRI.
    • Enter your domain names.
    • Enter a time server if applicable.
    • Enter the time zone region to be used for timestamps within NetMRI.
    • Enter the location within your time zone region.
    • Enter NetMRI IP address.
    • Enter the Subnet Mask for NetMRI.
    • Enter the IPv6 address if applicable.
    • Enter the IPv6 prefix if applicable.
    • Enter your default gateway for NetMRI.
    • Enter the IPv6 default gateway if applicable.
    • Enter n for the scan port.
    • Enter the DNS servers for NetMRI.
    • Review your settings. If you do not want to edit the settings, enter n.
    • Enter y to configure the server with the settings you just entered. Wait while NetMRI configures the network and sets the web interface to use the new IP address.
    • When prompted, enter y.
    • Restart the server and reboot.
    • At the shell prompt, type exit to log out.