Versions Compared

Version Old Version 20 New Version 21
Changes made by

Shwetha S (Deactivated)

Shwetha S (Deactivated)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.


Note
titleNote
  • From NIOS 9.0 onwards, IB-4030 and IB-4030-10GE appliances are not supported.
    Similar features are available on software based DNS cache acceleration appliances. You can enable them by using the DNS cache acceleration CLI commands.
  • From NIOS 9.0 onwards, all smartnic CLI commands are smartnic CLI commands (applicable only for hardware based DNS cache acceleration appliances) are replaced by dns-accel CLI commands.  For example, set smartnic log, is replaced as set dns-accel log.

The NIOS-based IB-4030 or IB-4030-10GE appliance provides several commands to change settings in the system. To use these commands, you must connect through SSH or connect through the serial console port to the IB-4030 or IB-4030-10GE and login with the appropriate admin account.
The IB-4030 or IB-4030-10GE appliance supports the standard NIOS command-line interface for communicating with the device. For more information see docs.infoblox.com, CLI section.

Supported IB-4030 and IB-4030-10GE CLI commands include the following:

...

The CLI commands listed below are frequently used on the appliance. For more information see docs.infoblox.com, CLI section.

set dns

The set dns command enables you to control the DNS cache. You can flush the cache of a DNS view or flush a particular entry from the cache.

...