...
For more information, see Configuring Virtual Scan Interfaces.
To configure a physical scan interface, complete the following:
- Go to Click the Settings icon > Setup > Scan Interfaces.
- Hover over the Action icon for any of the physical ports and select Edit from the menu.
- In Network View, choose one of the following:
- Select Existing: Choose a network view from the list of existing ones that are defined on the system:
- Select the view from the drop-down list.
- Selecting Unassigned as the Network View leaves the interface in a disabled state.
- Create New: Create a new network view:
- Enter the name for the new network view.
- Enter a comment describing the view. These values can be edited at a later time.
- Select Existing: Choose a network view from the list of existing ones that are defined on the system:
- Enter IPv4 or IPv6 information, or both:
- IPv4 Address: The IPv4 address for the scan interface.
- IPv4 Subnet Mask: The IPv4 subnet mask for the scan interface.
- IPv4 Default Gateway: The IPv4 default gateway for the scan interface.
- IPv6 Address: The IPv6 address for the scan interface.
- IPv6 Subnet Mask: The IPv6 subnet mask for the scan interface.
- IPv6 Default Gateway: The IPv6 default gateway for the scan interface.
- In Primary DNS Server, specify the primary DNS server for the scan interface.
- In Secondary DNS Server, specify the primary DNS server for the scan interface.
- In Search Domains, specify valid hostnames separated by commas.
- Click Save.
...