The The set interface interface command allows you to configure the speed and duplex settings of the network interfaces (MGMT, HA, LAN1, and LAN2) on single independent appliances only. You cannot configure the network interface settings of appliances after they join a Grid or become HA pairs.
You can use set interface mgmt to to enable the MGMT port and configure its IP address, netmask, and gateway address. You can configure either IPv4 address, IPv6 address or both for the MGMT interface of the appliance. Once the MGMT port is enabled, you can use the command to configure the speed and duplex settings of the MGMT port. You can also use set interface mgmt off to to disable the MGMT port.
Use the show interface command to view the interface settings.
...