The show recursion_query_timeout command displays the maximum time allowed for a recursive query to wait for a response before timing out.
You can use the ser recursion_query_timeout command to configure the recursion query timeout value. For information, see set recursion_query_timeout. Setting the timeout value to 0 returns to the default timeout behavior, which is to wait at least 30 seconds and up to 40 seconds before timing out.

Note: When you enable this on an HA pair, ensure that you run the command and set the same values on both nodes of the HA pair. No service restart is required when you use this command.

These commands are designed to mitigate phantom domain attacks. For more information about this, refer to the Infoblox NIOS Administrator Guide.

Syntax

show recursion_query_timeout

Example

Infoblox > show recursion_query_timeout
Recursion query timeout (in seconds): Default (30)

Browser not supported