The debug command enables debug level logs from NetMRI services to be displayed and compiled into a text file.

Note

Do not run the debug command from your system without instructions from Infoblox Support.

Syntax

To enable or disable debugging, run the following command:

debug <service> enable|disable

To view a list of services or devices for which debugging is or can be enabled, run the following command:

debug show-active|debug show-valid

The following table describes the subcommands of the debug command.

Subcommand	Description
`enable`	Enables debugging for the service.
`disable`	Disables debugging for the service.
`show-active`	Displays the services or devices with enabled debugging.
`show-valid`	Displays the services for which debugging can be enabled.

Browser not supported