infoblox_ipv4_network Data Source

The data source for the network object allows you to get the following parameters for an IPv4 network resource:

To retrieve information about IPv4 networks that match the specified filters, use the filters argument and specify the parameters mentioned in the below table. These are the searchable parameters of the corresponding object in Infoblox NIOS WAPI. If you do not specify any parameter, the data source retrieves information about all IPv4 networks in the NIOS Grid.

The following table describes the parameters you can define in an infoblox_ipv4_network data source block:

*Aliases are the parameter names used in the prior releases of Infoblox IPAM Plug-In for Terraform. Do not use the alias names for parameters in the data source blocks. Using them can result in error scenarios.

Example of an IPv4 Network Data Source Block

resource "infoblox_ipv4_network" "net2" {
    cidr = "192.168.128.0/20"
    network_view = "nondefault_netview"
    reserve_ip = 5
    gateway = "192.168.128.254"
    comment = "small network for testing"
    ext_attrs = jsonencode({
      "Site" = "bla-bla-bla... testing..."
    })
}

data "infoblox_ipv4_network" "nearby_network" {
    filters = {
      network = "192.168.128.0/20"
      network_view = "nondefault_netview"
    }
    // This is just to ensure that the network has been be created
    // using 'infoblox_ipv4_network' resource block before the data source will be queried.
    depends_on = [infoblox_ipv4_network.net2]
}

output "ipv4_net1" {
    value = data.infoblox_ipv4_network.nearby_network
}

// searching for IPv4 networks by specifying EA's
data "infoblox_ipv4_network" "ipv4_net_ea" {
    filters = {
      "*Site" = "Custom network site"
      "*Site!" = "Office network site"
    }
}

// retrieves matching IPv4 networks with EA, if any
output "net_ea_out" {
    value = data.infoblox_ipv4_network.ipv4_net_ea
}