After a device is discovered by NetMRI, its detected Name, Device Type (Switch, Router, Switch-Router, etc...), or its management IP address can be edited by hand in this section. Doing so will remove the device from auto-discovery. To re-enable auto-discovery for that device, go to the Network Explorer > Discovery page and delete the device from the table. NetMRI will then re-discover the device after its defined time period between Discovery passes elapses.
The Device Viewer provides a General Settings page (Device Viewer > Settings & Status > General Settings) in which you can perform the following:
Enable/disable SNMP data gathering for the device.
Under SNMP Status, select Enabled to enable SNMP collection for the current device, and select Disabled to disable SNMP collection.Enable SNMP debugging as a troubleshooting aid.
Under SNMP Debug, select Enabled to enable SNMP debugging for the device. For more information, see the Collecting Troubleshooting Data topic.Enable SDN debugging as a troubleshooting aid.
Under SDN Debug, select Enabled to enable SDN debugging for the device. For more information, see the Collecting Troubleshooting Data topic.Override the device Name and Type determined automatically by the appliance. This triggers rediscovery. For more information, see Overriding Device Names and Types in the Device Viewer.
Override the config change setting specified in the Device Group to define config collection for the device as Locked or Unlocked.
Set the Reboot Time, in YYYY-mm-dd hh:mm:ss format, for devices up longer than 497 days.