The show ipv6_bgp command displays the local NIOS appliance's IPv6 BGP configuration, reachability information about neighbors, and BGP routes to destinations. You can specify the command with or without an argument. A command without an argument defaults to show bgp route.
For information about how to write statistical information to syslog, see set bgp log.

Syntax

show ipv6_bgp {route | neighbor | summary | config}

Argument	Description
`route`	Displays the BGP routing table.
`summary`	Displays the BGP protocol summary.
`neighbor`	Displays information about all known BGP neighbors. If only IPv4 BGP information is available, this command option displays IPv4 information.
`config`	Displays the running BGP configuration file, including all IPv4 and IPv6 configuration, prefix lists and access-lists.

If no applicable information is available (for example, the current device has no IPv6 BGP configuration and hence no IPv6 BGP neighbor information), you are returned to the NIOS CLI prompt.

Example

Infoblox > show ipv6_bgp summary
BGP router identifier 10.34.1.179, local AS number 1 RIB entries 3, using 288 bytes of memory
Peers 1, using 4560 bytes of memory

Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd 10.34.1.178 4 10 192542 240631 0 0 0 02:45:16 0

Total number of neighbors 1 Infoblox > show ipv6_bgp neighbor
BGP neighbor is 2001:1938:BA8::22AA:1, remote AS 10, local AS 1, external link BGP version 4, remote router ID 10.36.1.66 BGP state = Established, up for 02:11:21
Last read 14:34:06, hold time is 16, keepalive interval is 4 seconds Neighbor capabilities:
4 Byte AS: advertised and received
Route refresh: advertised and received(old & new) Address family IPv4 Unicast: advertised and received Address family IPv6 Unicast: advertised and received Message statistics: Inq depth is 0 Outq depth is 0

Inq depth is 0 Outq depth is 0

Sent Rcvd Opens: 118 25

Notifications: 13 88 Updates: 219 0 Keepalives: 239773 192022 Route Refresh: 0 0 Capability: 0 0 Total: 240123 192135

Enter <return> for next page or q<return> to go back to command line. Minimum time between advertisement runs is 30 seconds
For address family: IPv4 Unicast NEXT_HOP is always this router
Community attribute sent to this neighbor(both) Inbound path policy configured
Outbound path policy configured
Incoming update prefix filter list is *DEFAULT Outgoing update prefix filter list is *ANYCAST
0 accepted prefixes

For address family: IPv6 Unicast
Community attribute sent to this neighbor(both)
0 accepted prefixes

Connections established 73; dropped 72
Last reset 02:13:50, due to BGP Notification send

Local host: 10.34.1.179, Local port: 179
Foreign host: 10.34.1.178, Foreign port: 43135
Nexthop: 10.34.1.179

Nexthop global: 2001:db8:a22:1b0::3 Nexthop local: fe80::230:48ff:febc:9503 BGP connection: non shared network
Read thread: on Write thread: off

Browser not supported