You can check the overall system settings for the current NetMRI appliance anytime. Click the Settings icon and then Settings > Setup > Settings Summary to get a quick look at many basic aspects of the system–license limits and configuration, basic network configuration, settings for configuration data collection, and other functional areas through which NetMRI does its work.

• NetMRI Configuration: This panel shows the NetMRI version, model, serial number, and license limit settings.
• Network Configuration: This panel displays the NetMRI network domain settings as configured during step one of the installation process.
• MGMT Interface Configuration: This panel displays the configuration settings for the NetMRI management interface.
• Device and Interface Counts: This panel displays the current number of network devices and interfaces that NetMRI discovers up to the current time through its data collection across the network. Note the Total Interfaces and Up Interfaces counters, along with Frequently Polled  Interfaces, and any possible differences between Network Devices Seen and Managed Network Devices.
• Collector Settings: This panel displays the status of each collector used for gathering information about the networks that NetMRI analyzes and monitors. Some collectors may be disabled if the required license is not installed. Enable collectors at Settings > Setup > Collection and Groups.
• Module Settings: This panel displays the current NetMRI software version. The possible versions are the following: Switch Port Manager, Automation Change Manager, and full NetMRI.
• License Configuration: This panel identifies the current license information and provides a hyperlink to a page for updating your NetMRI license.

Many of these settings are defined through the Setup Wizard.