...
- Configure two supported NetMRI appliances with licenses installed.
- Both the appliances must be of the same appliance model and same software version number.
- Provision of three IP addresses on the same subnet: A VIP address and two management IP addresses for the appliances.
- If you are using the direct replication method to connect both appliances, you need an Ethernet cable to connect the systems directly through their HA Ports.
- If you are using the network replication method to connect the appliances, you must connect the systems over a local network and two replication IP addresses must be acquired on the same subnet. You must also select a TCP port for the replication traffic.
...
4. Configure the failover settings on the Operation Center and collectors, as described in Specifying Automatic Failover Settings.
Note | ||
---|---|---|
| ||
After specifying the failover configuration settings and completing the enable operation, the systems start synchronizing data. This process might take up to one hour, depending on the appliance model. |
...