...
3. Run the Setup Wizard on both appliances, set the admin password, and then install the license. The admin password must be the same on both systems. For more information, see Running the Setup WizardRunning the Setup Wizard.
At this point in time, it is not necessary to complete the entire configuration wizard on both systems. You can complete the configuration only on the primary system.
4. Configure the failover settings on the Operation Center and collectors, as described in Specifying Automatic Failover Settings.
Note | ||
---|---|---|
| ||
After specifying the failover configuration settings and completing the enable operation, the systems start synchronizing data. This process might take up to one hour, depending on the appliance model. |
5. For an Operation Center and collector failover, complete the following:
- Log in to the administrative shell on the Operation Center and run the
configure tunserver
command. Enter the VIP address of the Operation Center when prompted for the IP address of the Operation Center server. - To register the collector on the Operation Center set up, log in to the administrative shell on each Collector and run the
register tunclient
command. Enter the VIP address of the Operation Center when prompted for the IP address of the Operation Center.
- Log in to the administrative shell on the Operation Center and run the