Page Comparison

...

1. Install NetMRI with the same version as on node A. If you are using a device that you used earlier, update it to the node A version.
2. If the device was already used, run the reset command on node B.
3. Run the repartition command on node B.
4. The

   Run the config server command on node B. 

   Note

   title	Note

   
    The management port should be in the same network, time zone, etc. as in node A. If you are using scan ports, connect the scan ports of the second node to the network in the same way as in the existing device. For more information, see Failover and Scan Interfaces.

5. Install the license on node B. The license must have the same type, device limit, and expiration date as node A.

   NotetitleNote

   
   In the case of an Operation Center, run config server again after the license installation without modifying any parameters.

6. Reset the admin password in the GUI to match the other system or make UI setup through the Setup Wizard.

...