Preparing Secondary Appliances (Old Partition Scheme)

To prepare a secondary (B) device, complete the following:

1. Install NetMRI with the same version as on node A. If you are using a device that you used earlier, update it to the node A version.
2. If the device was already used, run the reset command on node B.
3. Run the repartition command on node B.

4. Run the config server command on node B.
    The management port should be in the same network, time zone, etc. as in node A. If you are using scan ports, connect the scan ports of the second node to the network in the same way as in the existing device. For more information, see Failover and Scan Interfaces.

5. Install the license on node B. The license must have the same type, device limit, and expiration date as node A.
   In the case of an Operation Center, run config server again after the license installation without modifying any parameters.

6. Reset the admin password in the GUI to match the other system or make UI setup through the Setup Wizard.

You now have the new node with the new partition scheme prepared to participate in the HA pair.