...
Note | ||
---|---|---|
| ||
Anycast must be enabled on the on-prem host prior to configuring it for use with on-prem host. For information on enabling the on-prem host for anycast, see Viewing and Modifying On-Prem Host Configuration. |
To add an Anycast Configuration Profile to an On-Prem a Host, complete the following:
- From the Cloud Services Portal, click Manage -> On-Prem > Hosts.
- Select the on-prem host to be configured from among the list of on-prem hosts.
- Click Service and then select Anycast.
- From the Anycast options, select Configure to open the Configure Anycast page.
- In the ANYCAST CONFIG PROFILE section, click Add to add an available Anycast Configuration to the profile.
- In the Add IPv4 OSPF Area section of the OSPF Configuration section, complete the following:
- Area Type: Choose Standard, NSSA, or Stub from the options.
- Area ID: Add the Area ID in the Area ID field.
- Advertising Interface: Add the name of the advertising interface in the Advertising Interface field.
- Authentication Type: Choose either Clear or MD5 from the list options.
- Key: Add the key value in the Key field.
- Cost: Add the cost to the Cost field.
- Hello Interval(s): Add the hello interval in the Hello Interval(s) field.
- Dead interval(s): Add the dead interval in the Dead Interval(s) field.
- Retransmit Interval(s): Add the retransmit interval in the Retransmit Interval(s) field.
- Transmit Delay(s): Add the transmit delays in the Transmit Interval(s) field.
- Click Add to save the OSPF configuration.
...
9. Click Save & Close to save the Anycast On-Prem Host configuration.