Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

In the Interface Binding step of the Edit <Service> wizard, you bind the service you plan to create to specific network interfaces. Interface binding can be useful if you want to separate traffic due to security reasons. For example, if your organization uses a gateway to separate the internal network (LAN) from external networks (WAN), you can bind the service to an interface that separates the service traffic from other traffic. Binding the service to WAN, which covers a large geographic area including the Internet, ensures that the service traffic is separated from LAN, which usually cover your organization’s internal network.

Note: Before you can bind the service to network interfaces on the host, ensure that you have properly set up the interfaces on the host. Otherwise, you will not be able to bind the service to the desired interfaces.

To bind your service to network interfaces, complete the following:

  • All Interface Binding: Select this check box to bind the service to all network interfaces. Deselect this if you want to choose either WAN or LAN for binding.

  • WAN: Select this to bind the service to WAN.

  • LAN: Select this to bind the service to LAN.

NETWORK INTERFACES

This section displays the following information about the network interfaces that have been configured on the host:

  • HOST NAME: The host name as provided.

  • NETWORK INTERFACE:  The network interface used by the service instance.

  • INTERFACE TYPE: The type of network interface used to bind the service instance.

  • NETWORK LABEL: The provided label for the network.

  • IPv4 ADDRESS: The IPv4 address of the network interface.

  • IPv6 ADDRESS: The IPv6 address of the network interface.

Click Next to proceed to the next step. Note that all required information must be added prior to proceeding to the next step. If any required information is left empty, you will see an error icon next to the page.

To change information in the previous step, click Back to return to the previous page, or click Cancel to exit without saving the configuration. If you have completed all edits and configuration, click Finish.

 

  • No labels