Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

Version 1 Current »

If you are using DHCP with NetMRI, record the IP address that is assigned to NetMRI, and then continue the configuration as described in Configuring NetMRI Using the Setup Wizard.
If you are configuring a static IP for NetMRI, complete the following:

  1. At the CLI (command-line interface) command prompt, enter configure ip, and then complete the following:
    • Enter the Management IP Address: The IPv4 address of the management interface of the NetMRI, for example, 192.168.10.10.
    • Enter the Management Subnet Mask: The subnet mask of the management interface of the NetMRI, for example, 255.255.255.0.
    • Enter the Management Gateway Address: The IPv4 default gateway of the management interface of the NetMRI, for example, 192.168.10.1.
    • Enter the Primary DNS Server: The primary DNS server for the NetMRI to query, for example, 172.23.16.20.
    • Enter the Primary DNS Domain: The DNS domain name for the NetMRI, for example, infoblox.local.
  2. In the Current Settings section, review your entries.
  3. At the Edit these settings? <y/n> [n] prompt, enter n and then press Enter.
  4. At the Configure these IP settings? <y/n> [y] prompt, enter y to configure the IP settings. Wait while NetMRI configures the network and sets the web interface to use the new IP address.
  5. When prompted, enter y to complete the configuration.
  6. At the command prompt, enter configure server, and then complete the following (values you entered in the configure ip command will be the default values here):
    • Enter y to continue.
    • Enter your network name, for example, MyNetwork.
    • Enter your server name, for example, MyNetMRI.
    • Enter your domain names.
    • Enter a time server if applicable.
    • Enter the time zone region to be used for timestamps within NetMRI.
    • Enter the location within your time zone region.
    • Enter NetMRI IP address.
    • Enter the Subnet Mask for NetMRI.
    • Enter the IPv6 address if applicable.
    • Enter the IPv6 prefix if applicable.
    • Enter your default gateway for NetMRI.
    • Enter the IPv6 default gateway if applicable.
    • Enter n for the scan port.
    • Enter the DNS servers for NetMRI.
    • Review your settings. If you do not want to edit the settings, enter n.
    • Enter y to configure the server with the settings you just entered. Wait while NetMRI configures the network and sets the web interface to use the new IP address.
    • When prompted, enter y.
    • Restart the server and reboot.
    • At the shell prompt, type exit to log out.
  • No labels