Powering the Appliance

The Trinzic 1410, Trinzic 1420 and ND-1400 appliances ship with one (1) hot-swappable AC power supply module or one DC power supply module. You can order an additional power supply to set up a redundant 1+1 configuration. In the 1+1 configuration, Infoblox recommends using the power cables that ship with the appliances to connect each power supply to separate power circuits. In the event of a power failure on one circuit, the appliances can then operate on the other.

Note: If your appliance comes with one power supply and an empty module, ensure that the power supply is in the PSU #1 slot and the empty module in the #2 slot. You cannot switch them.

To power the appliance:

• Connect a power cable between the power connector on the back of the appliance and a properly grounded and rated power circuit that meets the provisions of the current edition of the National Electrical Code, or other wiring rules that apply to your location. Make sure that the outlet is near the appliance and is easily accessible.