/
Configuring the Operations Center Controller with Factory Defaults
Document toolboxDocument toolbox

Configuring the Operations Center Controller with Factory Defaults

Owned by Panna .
Nov 22, 2022

This procedure describes the process of setting up an Operations Center Controller with factory defaults. No configuration data or network and device information are imported from any NetMRI reference system.

To configure the Operations Center Controller with factory defaults:

  1. Log in to the NetMRI administrative shell.
  2. Enter the configure tunserver command.
  3. When prompted to Enter the reference system serial number or RETURN to skip, press Enter.
  4. Proceed to build out the system by following the procedures in the section Installing the Operations Center Controller.