/
Configuring a Failover Pair
Document toolboxDocument toolbox

Configuring a Failover Pair

Owned by Panna .
Oct 04, 2023

To configure a failover pair from the prepared appliances, complete the following:

  1. Log in to the Operation Center UI as admin.
  2. Go to the Settings icon > Setup > Failover Configuration. Here you can see the HA status of your devices scheme (OC and 2 collectors).
  3. Choose OC > Edit and configure the Operation Center HA pair. Wait until it is finished and the status is OK.
  4. Choose the first collector > Edit and configure the first collector HA pair. Wait until it is finished and the status is OK.
  5. Choose the second collector > Edit and configure the second collector HA pair. Wait until it is finished and the status is OK.

Note

If the failover status is not OK (e.g. Standalone/Replication Down/Not Synced), wait about an hour and try to make a resynchronization from the secondary device.

Now you obtained a NetMRI scheme with HA appliances.

Related content