The reset all command clears the NIOS appliance of database, configuration, and network settings. It then re-establishes the factory settings with the default IP address, gateway, and subnet mask.
The reset all licenses command clears database, configuration, and network settings. It also clears all licensing information from the appliance before re-establishing the factory settings.
The reset all auto_provision command clears database, configuration, and network settings. It also re-enables auto-provisioning and a dynamic IP address is assigned to the appliance.

Note: No previous data remains on the appliance after using these commands.

Syntax

reset all [licenses | auto_provision]

Examples

Re-establish factory settings

Infoblox > reset all
The entire system will be reset to default settings.
WARNING: THIS WILL ERASE ALL DATA AND LOG FILES THAT HAVE BEEN CREATED ON THIS SYSTEM. ARE YOU SURE YOU WANT TO PROCEED? (y or n): y

Re-establish factory settings and remove all licenses

Infoblox > reset all licenses
The entire system will be reset to default settings and all licenses will be removed. WARNING: THIS WILL ERASE ALL DATA AND LOG FILES THAT HAVE BEEN CREATED ON THIS SYSTEM. ARE YOU SURE YOU WANT TO PROCEED? (y or n): y

Re-establish factory settings and re-enable auto-provisioning

Infoblox > reset all auto_provision
The entire system will be reset to default settings and system will try to obtain a dynamic address.
WARNING: THIS WILL ERASE ALL DATA AND LOG FILES THAT HAVE BEEN CREATED ON THIS SYSTEM. ARE YOU SURE YOU WANT TO PROCEED? (y or n): y