The show ip_rate_limit command displays the current rate limiting rules. You configure rate limiting rules to limit access or block connections from external sources. The rules take effect immediately when you enable rate limiting. For information on rate limiting and on how to configure rate limiting rules, see set ip_rate_limit.

Syntax

show ip_rate_limit

This command has no arguments.

Example

Viewing the current rate limiting rules

IP rate limiting is enabled.
Source            Limit               Burst
============================================
10.10.1.1        0 packets/minute     0 packets
10.10.1.2        5 packets/minute     5 packets
10.10.2.1/24     5 packets/minute     10 packets
all              5000 packets/minute  5000 packets