The Infoblox TE-2306 appliance uses a RAID (Redundant Array of Independent Disks) 10 array to provide the optimum mix of high database performance and redundant data storage with recovery in the event of disk failures. The disk array is completely self managed, with no maintenance or special procedures required to service the disk subsystem.
RAID 10 (or sometimes called RAID 1+0) uses a minimum of four disk drives to create a RAID 0 array from two RAID 1 arrays, as shown in the figure RAID 10 Array Configuration. It uses mirroring and striping to form a stripe of mirrored subsets. The RAID array combines—or stripes—multiple disk drives, creating a single logical volume (RAID 0). RAID 10 combines the high performance of RAID 0 and the high fault tolerance of RAID 1. Striping disk drives improves database write performance over a single disk drive for large databases. The disks are also mirrored (RAID 1), so that each disk in the logical volume is fully redundant.

RAID 10 Array Configuration

Open

Evaluating the Status of the Disk Subsystem

You can monitor the disk subsystem through Grid Manager and the LEDs for the disk drives. You can also view disk status by using the CLI command show hardware_status.

To see a detailed status report, log in to Grid Manager and from the Grid -> Grid Manager tab, select the appliance, and then click the Detailed Status icon. (For more information on the Detailed Status panel, refer to the Infoblox NIOS Documentation.)

The color of the RAID icon on the Detailed Status panel indicates the status of the RAID array on Infoblox TE-2306 series appliances:

Grid Manager also displays detailed status of the RAID array. In the event of a disk failure, you must replace the failed disk with one that is qualified and shipped from Infoblox and has the same disk type as the rest of the disks in the array. The appliance displays information about mismatched disks in the Detailed Status panel.

Note that all disk drives in the array must have the same disk type (IB-Type 5) for the array to function properly. When you have a mismatched disk in the array, promptly replace the disk with a replacement disk from Infoblox to avoid operational issues.

Disk LED Operation

The disk drives are located on the left side of the appliance front panel behind a removable face plate. A single LED, the top LED on the right, indicates the activity and status of each drive. The LEDs are not visible unless you remove the face plate. To do so, gently grip the left edge of the face plate and pull towards the front.
Disk Drive LED