/
Rack Mounting
Document toolboxDocument toolbox

Rack Mounting

Owned by Jyothi KP
Last updated: Jul 22, 2022 by Gary Leicht

The Trinzic 100 appliance mounts into a standard 19" (48 cm) equipment rack. You can purchase an accessory kit (Part Number: T-100-RACKKIT) that contains the following: a pair of rack brackets, a power adapter clamp with two captive screws, four (4) 6-32 screws, and four (4) 10-32 screws. For information about the accessory kit, contact your Infoblox sales representative. To mount the appliance to an equipment rack, you also need a #2 screwdriver with a cross-headed tip.
To mount the appliance to an equipment rack:

  1. Carefully place the Trinzic 100 appliance on a flat surface with its bottom side up.
  2. Attach the two rack brackets to the chassis using two (2) 6-32 screws on each bracket, as shown in Figure 4.

Figure 4 Attaching Rack Brackets to the Chassis
 


    3. Flip the appliance/rack bracket assembly over and put it on a flat surface.
    4. Place the power adapter over the "PLACE POWER ADAPTER HERE" area on either the right or left rack bracket, as shown in Figure 5. Ensure that the AC input faces the rear of the appliance and the DC output faces toward the front. You can use the cable management brackets to route the DC cable to the rear of the appliance.

Figure 5 Placing the Power Adapter on the Rack Bracket

    5. Place the power adapter clamp on top of the power adapter, and then secure the clamp to the rack bracket by sliding the tabs on the clamp under the clips on the rack bracket, as shown in Figure 6.

Figure 6 Securing the Clamp on the Power Adapter

    6. Gently press the clamp down and secure the clamp to the rack bracket by tightening the captive screws, as shown in Figure 7.

Figure 7 Tightening the Captive Screws on the Clamp
 

    7. Optionally, route the IO cables to the front of the appliance through the opening on the front of the rack bracket.
    8. Place the entire assembly on an equipment rack and secure the rack ears to the rack with two (2) 10-32 screws on each side of the rack, as shown in Figure 8.

Figure 8 Securing Rack Ears to the Rack

Note: If you choose not to rack-mount the Trinzic 100 appliance, place the unit horizontally on a stable, cool flat surface, resting on all four rubber feet.