The show ipv6_ospf command displays configuration and statistical information about the OSPFv3 protocol (if any) running on the NIOS appliance. For information on changing OSPF log settings, see set ipv6_neighbor.

Syntax

show ipv6_ospf {route | interface | database | neighbor | configuration}

Argument	Description
`route`	Displays the OSPF routing table, as determined by the most recent SPF calculation.
`interface`	Displays the state and configuration on all interfaces configured with OSPF.
`database`	Displays all OSPF database information.
`neighbor`	Displays the OSPF neighbor information.
`configuration`	Displays the running OSPF configuration file.

Examples

Infoblox > show ipv6_ospf OSPFv3 Routing Process (0) with Router-ID 10.34.1.179 Running 11d03:14:41 Number of AS scoped LSAs is 2 Number of areas in this router is 1 Area 0.0.0.61 Number of Area scoped LSAs is 4 Interface attached to this area: eth1

Infoblox > show ipv6_ospf interface eth1 is up, type BROADCAST Interface ID: 11 Internet Address: inet : 10.34.1.179/29 inet6: 2001:db8:a22:1b0::3/64 inet6: fe80::230:48ff:febc:9503/64 Instance ID 0, Interface MTU 1500 (autodetect: 1500) MTU mismatch detection: enabled Area ID 0.0.0.61, Cost 1 State BDR, Transmit Delay 1 sec, Priority 1 Timer intervals configured: Hello 10, Dead 40, Retransmit 5 DR: 255.1.1.1 BDR: 10.34.1.179 Number of I/F scoped LSAs is 2 0 Pending LSAs for LSUpdate in Time 00:00:00 [thread off] 0 Pending LSAs for LSAck in Time 00:00:00 [thread off] eth2 is down, type BROADCAST