configure command
- Viktoryia Varapayeva (Deactivated)
The configure command is essentially the command-line equivalent of the Settings icon > General Settings > Security page.
Syntax
The following is the command syntax:
configure <setting> [show|reset]
The following table describes the settings that you can configure in the administrative shell.
| Setting | Description |
|---|---|
| Installs an SSL certificate into the NetMRI system for HTTPS sessions. |
| Determines whether the HTTP and HTTPS servers are activated in the NetMRI system. You can also enable or disable individual encryption protocols in the HTTPS suite. By default, NetMRI enables all protocol options. You must restart the services after making any changes, which consists of a full restart of NetMRI. |
| Starts the configuration for standalone NetMRI and Operations Center Controllers and Collectors. During this configuration, you specify network name, NetMRI server name, domain name, time server, time zone, NetMRI IP address and subnet mask, and several other basic operating parameters. |
| Enables or disables support for specific SNMP protocol types, and defines the community string and the SNMP passphrase. |
| Defines basic settings for SSH client and NetMRI SSH server, including enabling or disabling either communications protocol and the type or types of encryption protocols supported by each. Under most circumstances, the defaults should be retained unless organization policy requires specific settings. You must restart the services after making any changes. |
or
| Initiates configuration of an appliance that is licensed as an Operations Center Controller (after running license and configure server) to set up or reset VPN components and allow Collectors to communicate with the Controller. configure tunserver or configure tunclient must be performed before Collectors can register with the Controller. For more information, see Infoblox Deployment Guide for NetMRI and Operations Center. |
reset | Resets all systems to the factory default. |