The refreshgroups command directs NetMRI to rebuild all defined Interface Groups and Device Groups in the local appliance. The refreshed group data appears in the NetMRI UI after a few moments.

Syntax

The following is the command syntax:

refreshgroups

Example

netmrivm193> refreshgroups

Requesting regeneration of 22 device groups...

App Servers...request sent.

App Servers w/o SNMP...request sent.

Development Lab Network...request sent.

IT Services...request sent.

IT Services w/o SNMP...request sent.

NAME ONLY...request sent.

Network Low-Level...request sent.

Network Management...request sent.

Network Pending...request sent.

Network w/o SNMP...request sent.

NIOS...request sent.

Optimizers...request sent.

Routing...request sent.

Security...request sent.

Switching...request sent.

UNKNOWN...request sent.

Video...request sent.

Voice...request sent.

Wireless...request sent.

Workstations...request sent.

Workstations w/o SNMP...request sent.

Requesting regeneration of 4 interface groups...

Active Router Interfaces...request sent.

Admin Down...request sent.

Switch Ports...request sent.

Trunk Ports...request sent.

Depending on the size of the network, it may take a few minutes for the results to be reflected in the user interface. On an OC, it will take an extra minute or so as the calculations are done on the collectors and transferred up to the OC.