admin > wizard

The admin > wizard command allows you to configure the network settings.

Syntax

admin > wizard

Example

admin > wizard
Please use: '?' for help on available command options.
Do you want to configure admin network settings y/n [y]:
y


Please use: '?' for help on available command options.
Please enter IPv4 configuration in format: 'mode [gateway address mask vlanid]'
Current settings are [ dynamic ]:
static 10.36.0.1 10.36.130.1 255.255.0.0 0
ok
Please enter dns configuration[ 10.0.0.0 ]:
10.0.0.0
DNS servers obtained by DHCP (if any) have higher precedence
ok
Please enter domain configuration[ static [gateway=10.36.0.1 address=10.36.130.1 2 mask=255.255.0.0 vlanid=0] ]:
Settings unchanged.
Please enter hostname configuration[ hostname.com ]:
hostname.com
ok
Configured System Setting:
gateway: 10.36.0.1
mask: 255.255.0.0
mode: static
address: 10.36.130.1
vlanid: 0
vlan configuration is only in effect in the static mode.
Network configuration in progress...
Configured DNS Setting:
Dns Server(s): ['10.0.0.0']
domain: static [gateway=10.36.0.1 address=10.36.130.12 mask=255.255.0.0 vlanid=1
0.2.3.4]
hostname: hostname.com
Is it correct? y/n [y]:
y
Updating network interface configuration is in progress (It may take few seconds)...
Do you want to configure admin system settings y/n [y]:
y
Please use: '?' for help on available command options.
Please enter Greeting banner text[ Configured System Setting: ]:
This is Infoblox Data Connection Virtual Machine
ok
This is Infoblox Data Connection Virtual Machine
Is it correct? y/n [y]:
y
Setup wizard finished successfully