failover command

Use the failover command to enable, disable, or configure failover settings on appliances.

The following is the command syntax:

The following table describes the subcommands of the failover command.

Subcommand	Description
`enable`	Enables failover on the appliance.
`disable`	Disables failover on the appliance.
`show`	Displays the current failover configuration on the appliance.
`edit`	Allows you to edit the failover settings on the appliance.
`status`	Displays the current failover status of the appliance.
`role <primary\|secondary>`	Allows you to change the role of the appliance.
`resync`	Syncs the appliances to verify their assigned roles are correct.

Example

netmrivm193> failover show

Date: Tue Jun 7 10:33:57 2022
Status: Off
Virtual IP address:
Virtual Hostname:
Connection Mode: Direct

[Node 1] Role: PRIMARY
Hostname: netmrivm193-DEV
Serial Number: netmrivm193
Management IP: 172.19.4.111

[Node 2] Role: SECONDARY
Hostname:
Serial Number:
Management IP:

netmrivm193>