show ipv6_ospf
The show ipv6_ospf
command displays configuration and statistical information about the OSPFv3 protocol (if any) running on the NIOS appliance. For information on changing OSPF log settings, see set ipv6_neighbor.
Syntax
show ipv6_ospf {route | interface | database | neighbor | configuration}
Argument | Description |
---|---|
route | Displays the OSPF routing table, as determined by the most recent SPF calculation. |
interface | Displays the state and configuration on all interfaces configured with OSPF. |
database | Displays all OSPF database information. |
neighbor | Displays the OSPF neighbor information. |
configuration | Displays the running OSPF configuration file. |
Examples
Infoblox > show ipv6_ospf
OSPFv3 Routing Process (0) with Router-ID 10.34.1.179
 Running 11d03:14:41
 Number of AS scoped LSAs is 2
 Number of areas in this router is 1
 Area 0.0.0.61
   Number of Area scoped LSAs is 4
   Interface attached to this area: eth1
Infoblox > show ipv6_ospf interface
eth1 is up, type BROADCAST
 Interface ID: 11
 Internet Address:
   inet : 10.34.1.179/29
   inet6: 2001:db8:a22:1b0::3/64
   inet6: fe80::230:48ff:febc:9503/64
 Instance ID 0, Interface MTU 1500 (autodetect: 1500)
 MTU mismatch detection: enabled
 Area ID 0.0.0.61, Cost 1
 State BDR, Transmit Delay 1 sec, Priority 1
 Timer intervals configured:
 Hello 10, Dead 40, Retransmit 5
 DR: 255.1.1.1 BDR: 10.34.1.179
 Number of I/F scoped LSAs is 2
 0 Pending LSAs for LSUpdate in Time 00:00:00 [thread off]
 0 Pending LSAs for LSAck in Time 00:00:00 [thread off]
eth2 is down, type BROADCAST