The set ipv6_status command enables or disables IPv6 on all interfaces. This is not a permanent enable or disable. If you restart your system, IPv6 is enabled once again.

Syntax

set ipv6_status {enable | disable}

Argument	Description
enable	Enables IPv6 on all interfaces.
disable	Disables IPv6 on all interfaces.

Example

Infoblox > set ipv6_status enable

WARNING: This operation will restart the product

Do you want to proceed? (y or n):y

Infoblox > show interface
MGMT:

IP Address: 10.36.111.3 MAC Address: 00:0C:29:70:D5:F5 Mask: 255.255.0.0 Broadcast: 10.36.255.255 MTU: 1500 Metric: 1 IPv6 Link: fe80::20c:29ff:fe70:d5f5/64 IPv6 Status: Enabled Negotiation: Disabled Speed: 1000M Duplex: Full Status: UP BROADCAST RUNNING MULTICAST

Statistics Information Received

packets: 25 bytes: 1518 (1.4 KiB) errors: 0 dropped: 0 overruns: 0 frame: 0

Transmitted

packets: 3 bytes: 218 (218.0 b) errors: 0 dropped: 0 overruns: 0 carrier: 0

Collisions: 0 Txqueuelen: 1000

Infoblox > set ipv6_status disable

WARNING: This operation will disable IPv6 communication Do you want to proceed? (y or n):y

Infoblox > show interface MGMT:

IP Address: 10.36.111.3 MAC Address: 00:0C:29:70:D5:F5 Mask: 255.255.0.0 Broadcast: 10.36.255.255 MTU: 1500 Metric: 1 IPv6 Link: IPv6 Status: Disabled Negotiation: Disabled Speed: 1000M Duplex: Full Status: UP BROADCAST RUNNING MULTICAST

Statistics Information

Received

packets: 606 bytes: 66780 (65.2 KiB) errors: 0 dropped: 0 overruns: 0 frame: 0

Transmitted

packets: 10 bytes: 540 (540.0 b) errors: 0 dropped: 0 overruns: 0 carrier: 0

Collisions: 0 Txqueuelen: 1000