The set security command allows you to specify IP or network addresses that can access the appliance through the GUI. The appliance denies access to addresses that are not specified. Use the show security command to view the security settings.

Syntax

set security

This command has no arguments.

Example

In the following example, security is enabled to restrict access to the NIOS appliance (through the GUI) to the IP address range 10.1.1.1:

Infoblox > set security
Enable security? (y or n): y
Enter access IP range: 10.1.1.1
Enter access netmask (Default: 255.255.255.0): 255.255.255.0
      New security settings:
   Security enabled: Yes
      IP range: 10.1.1.1
   Is this correct? (y or n): y
Do you wish to enter additional access range? (y or n): n