/
DTC PDP Monitor
Document toolboxDocument toolbox

DTC PDP Monitor

Owned by Jyothi KP
Last updated: Nov 21, 2024
2 min read

Use the nios_dtc_monitor_pdp module to create, update, or remove instances of the DTC PDP monitor object from a NIOS Grid. The DTC PDP monitor object is used to determine the health of a server by monitoring the response to a GTP ECHO request. For more information on the health monitor, refer to the Using DNS Traffic Control Health Monitors section in the Infoblox NIOS Documentation.

The following table describes the parameters you can define in the nios_dtc_monitor_icmp module:

Parameter

Required/Optional

Description

Parameter

Required/Optional

Description

name

Required

Specifies the display name for this DTC monitor.

port

Optional

Specifies the port number for the PDP request.
The default value is 2123.

interval

Optional

Specifies the interval for the PDP health check.
The interval value is measured from the end of the
previous monitor cycle. The default value is 5.

retry_down

Optional

Specifies the number of times the server should appear as down, for it to be treated as dead after it was alive.
The default value is 1.

retry_up

Optional

Specifies the number of times the server should appear as up, for it to be treated as alive after it was dead.
The default value is 1.

timeout

Optional

Specifies the timeout in seconds for the PDP health check. It is the duration that a monitor waits to receive a response after sending a request. If a response is not received, it considers the check as failed.
The default value is 15.

extattrs

Optional

Specifies extensible attributes for the DTC PDP monitor object.
This field accepts a set of key / value pairs for the configuration.

state

Optional

Specifies the state of the DTC PDP monitor instance in NIOS. Set one of the following values:

  • present (default): Configures the object on the device.

  • absent: Removes the object from the device.

comment

Optional

Describes the DTC PDP monitor object.

provider

Required

A dictionary object that contains the connection details.

  • host: DNS host name or IP address to connect to the remote instance of NIOS.

  • username: User name to use for authenticating the connection to the remote instance.

  • password: Password to use for authenticating the connection to the remote instance.

For information on additional fields you can define, see the list of subparameters in the NIOS Modules for Ansible Collections topic.

connection

Required

The nios_dtc_monitor_pdp module must be run locally.

Examples

name: Configure a DTC PDP monitor
infoblox.nios_modules.nios_dtc_monitor_pdp:
name: pdp_monitor
state: present
provider:
host: <nios_hostname_or_hostip>
username: admin
password: admin
connection: local

 

name: Add a comment to an existing DTC PDP monitor
infoblox.nios_modules.nios_dtc_monitor_pdp:
name: pdp_monitor
comment: this is a test comment
state: present
provider:
host: <nios_hostname_or_hostip>
username: admin
password: admin
connection: local

 

name: Remove a DTC PDP monitor from the system
infoblox.nios_modules.nios_dtc_monitor_pdp:
name: pdp_monitor
state: absent
provider:
host: <nios_hostname_or_hostip>
username: admin
password: admin
connection: local

Related content