The show routes command displays the current IPv4 and IPv6 routing information on the NIOS appliance and organizes the information according to the interface. This command is a valuable diagnostic tool for connectivity issues.

Syntax

show routes

This command has no arguments.

Example

In the following example, default specifies the direct connection to the interface and the static routes are represented (in this example) in bold. You specify static routes by manually entering them through the GUI.

Infoblox > show routes
From LAN:
10.34.33.0/24 dev eth1 scope link default via 10.34.33.1 dev eth1

From LAN2:
10.1.1.0/24 dev eth3 scope link default via 10.1.1.1 dev eth3

From IPv4 main route table:
10.34.33.0/24 dev eth1 proto kernel scope link src 10.34.33.11 10.1.1.0/24 dev eth3 proto kernel scope link src 10.1.1.35 default via 10.34.33.1 dev eth1
From IPv6 main route table:
fe80::/64 dev eth1 metric 256 expires 21257697sec mtu 1500 advmss 1440 metric10 4294967295
fe80::/64 dev eth3 metric 256 expires 21334065sec mtu 1500 advmss 1440 metric10 4294967295
ff00::/8 dev eth1 metric 256 expires 21257697sec mtu 1500 advmss 1440 metric10 4294967295
ff00::/8 dev eth3 metric 256 expires 21334065sec mtu 1500 advmss 1440 metric10 4294967295
default via fe80::204:96ff:fe1d:1980 dev eth1 proto kernel metric 1024 expires 1661sec mtu 1500 advmss 1440 metric10 64
default via fe80::204:96ff:fe1d:1980 dev eth3 proto kernel metric 1024 expires 1661sec mtu 1500 advmss 1440 metric10 64
unreachable default dev lo proto none metric -1 error -101 metric10 255