Document toolboxDocument toolbox

set ipv6_status

The set ipv6_status command enables or disables IPv6 on all interfaces. This is not a permanent enable or disable. If you restart your system, IPv6 is enabled once again.

Syntax

set ipv6_status {enable | disable}

Argument Description
enableEnables IPv6 on all interfaces.
disableDisables IPv6 on all interfaces.


Example

Infoblox > set ipv6_status enable

WARNING: This operation will restart the product

Do you want to proceed? (y or n):y

Infoblox > show interface
MGMT:

IP Address:  10.36.111.3      MAC Address: 00:0C:29:70:D5:F5
Mask:        255.255.0.0      Broadcast: 10.36.255.255
MTU:         1500             Metric:   1
IPv6 Link:           fe80::20c:29ff:fe70:d5f5/64
IPv6 Status:         Enabled
Negotiation: Disabled
Speed:       1000M            Duplex:      Full
Status:      UP BROADCAST RUNNING MULTICAST

Statistics Information
Received

packets:   25             bytes:    1518 (1.4 KiB)
errors:    0              dropped: 0
overruns:  0              frame: 0

Transmitted

packets:  3               bytes: 218 (218.0 b)
errors:   0               dropped: 0
overruns: 0               carrier: 0

Collisions: 0                Txqueuelen: 1000

Infoblox > set ipv6_status disable

WARNING: This operation will disable IPv6 communication
Do you want to proceed? (y or n):y

Infoblox > show interface
MGMT:

IP Address:   10.36.111.3       MAC Address: 00:0C:29:70:D5:F5
Mask:         255.255.0.0       Broadcast: 10.36.255.255
MTU:          1500              Metric: 1
IPv6 Link:
IPv6 Status:         Disabled
Negotiation: Disabled
Speed:       1000M              Duplex: Full
Status:      UP BROADCAST RUNNING MULTICAST

Statistics Information

Received

packets:  606            bytes: 66780 (65.2 KiB)
errors:   0              dropped: 0
overruns: 0              frame: 0

Transmitted

packets:  10             bytes: 540 (540.0 b)
errors:   0              dropped: 0
overruns: 0              carrier: 0

Collisions:   0             Txqueuelen: 1000